On Thu, Aug 18, 2011 at 08:58:53AM -0500, Seth Forshee wrote:

The case 3 code is nearly identical to case 2. How about this?

	case 2:
		__set_bit(BTN_TOOL_QUADTAP, dev->keybit);
		/* fall through */

	case 3:
		input_set_abs_params(dev, ABS_X, x_min, x_max, 0, 0);
		input_set_abs_params(dev, ABS_Y, y_min, y_max, 0, 0);
		/* range of pressure and width is the same as v2 */
		input_set_abs_params(dev, ABS_PRESSURE, ETP_PMIN_V2,
				     ETP_PMAX_V2, 0, 0);
		input_set_abs_params(dev, ABS_TOOL_WIDTH, ETP_WMIN_V2,
				     ETP_WMAX_V2, 0, 0);
		__set_bit(INPUT_PROP_SEMI_MT, dev->propbit);
		input_mt_init_slots(dev, 2);
		input_set_abs_params(dev, ABS_MT_POSITION_X, x_min, x_max, 0, 0);
		input_set_abs_params(dev, ABS_MT_POSITION_Y, y_min, y_max, 0, 0);
		break;

Sorry, that should have been:

	case 2:
		__set_bit(BTN_TOOL_QUADTAP, dev->keybit);
		/* fall through */

	case 3:
		input_set_abs_params(dev, ABS_X, x_min, x_max, 0, 0);
		input_set_abs_params(dev, ABS_Y, y_min, y_max, 0, 0);
		if (etd->reports_pressure) {
			input_set_abs_params(dev, ABS_PRESSURE, ETP_PMIN_V2,
					     ETP_PMAX_V2, 0, 0);
			input_set_abs_params(dev, ABS_TOOL_WIDTH, ETP_WMIN_V2,
					     ETP_WMAX_V2, 0, 0);
		}
		__set_bit(INPUT_PROP_SEMI_MT, dev->propbit);
		input_mt_init_slots(dev, 2);
		input_set_abs_params(dev, ABS_MT_POSITION_X, x_min, x_max, 0, 0);
		input_set_abs_params(dev, ABS_MT_POSITION_Y, y_min, y_max, 0, 0);
		break;