On 27.03.2025 13:38:22, Ming Yu wrote:

Marc Kleine-Budde [off-list ref] 於 2025年3月27日 週四 上午1:41寫道：

quoted

quoted

quoted

quoted

quoted

quoted

+     priv->can.clock.freq = can_clk;
+     priv->can.bittiming_const = &nct6694_can_bittiming_nominal_const;
+     priv->can.data_bittiming_const = &nct6694_can_bittiming_data_const;
+     priv->can.do_set_mode = nct6694_can_set_mode;
+     priv->can.do_get_berr_counter = nct6694_can_get_berr_counter;
+     priv->can.ctrlmode_supported = CAN_CTRLMODE_LOOPBACK |
+             CAN_CTRLMODE_LISTENONLY | CAN_CTRLMODE_BERR_REPORTING |
+             CAN_CTRLMODE_FD | CAN_CTRLMODE_FD_NON_ISO;

Does your device run in CAN-FD mode all the time? If so, please use
can_set_static_ctrlmode() to set it after priv->can.ctrlmode_supported
and remove CAN_CTRLMODE_FD from ctrlmode_supported.

Our device is designed to allow users to dynamically switch between
Classical CAN and CAN-FD mode via ip link set ... fd on/off.
Therefore, CAN_CTRLMODE_FD needs to remain in ctrlmode_supported, and
can_set_static_ctrlmode() is not suitable in this case.
Please let me know if you have any concerns about this approach.

Where do you evaluate if the user has configured CAN_CTRLMODE_FD or not?

Sorry, I was previously confused about our device's control mode. I
will use can_set_static_ctrlmode() to set CAN_FD mode in the next
patch.

Does your device support CAN-CC only mode? Does your device support to
switch between CAN-CC only and CAN-FD mode?

Our device supports both CAN-CC and CAN-FD mode.

This doesn't answer my question:

Does your device support CAN-CC only mode?

Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde          |
Embedded Linux                   | https://www.pengutronix.de |
Vertretung Nürnberg              | Phone: +49-5121-206917-129 |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-9   |