Re: [PATCH 1/5] dt-bindings: net: qca,ar803x: Add IPQ5018 Internal GE PHY support

From
Andrew Lunn <andrew@lunn.ch>
Date
2025-05-27 15:12:30
Also in
linux-arm-msm, linux-clk, linux-devicetree, lkml
Reply to
Konrad Dybcio, 2025-05-27
does this sound like a generic enough problem to contemplate something
common, or should we go with something like qcom,dac-preset-short-cable
I've seen a few other boards with back to back PHYs like this, and
they did not need any properties.

It could be this PHY does not conform to the standard, does not have
the needed dynamic range, and is getting saturated.

What we do have is:

  tx-amplitude-100base-tx-percent:
    description:
      Transmit amplitude gain applied for 100BASE-TX. 100% matches 2V
      peak-to-peak specified in ANSI X3.263. When omitted, the PHYs default
      will be left as is.

This is intended for actually boosting the amplitude, to deal with
losses between the PHY and the RJ-45 connector. So this is the
opposite.

The description of what the magic value does on this PHY suggests it
does more, and it cannot be represented as a percent. So i think a
vendor property is O.K.

   Andrew
Thread (34 messages) 34 messages, 6 authors, last reply 2025-05-28
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help