[PATCH v8 07/14] net: phy: at803x: add the possible_interfaces
flat view
STALE1017d
From: Luo Jie <hidden>
Date: 2023-12-15 07:41:10
Also in:
linux-devicetree, linux-doc, lkml
Subsystem:
ethernet phy library, networking drivers, the rest · Maintainers:
Andrew Lunn, Heiner Kallweit, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
Revision v8 of 2 in this series.
Revisions (2)
- v7 [diff vs current]
- v8 current
When qca808x works on the interface mode sgmii or 2500base-x, the interface mode can be switched according to the PHY link speed. Signed-off-by: Luo Jie <redacted> --- drivers/net/phy/at803x.c | 12 ++++++++++++ 1 file changed, 12 insertions(+)
diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index bb382089ab77..cd1bdb61d122 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c@@ -2179,10 +2179,22 @@ static void qca808x_link_change_notify(struct phy_device *phydev) QCA8081_PHY_FIFO_RSTN, phydev->link ? QCA8081_PHY_FIFO_RSTN : 0); } +static void qca808x_fill_possible_interfaces(struct phy_device *phydev) +{ + unsigned long *possible = phydev->possible_interfaces; + + if (phydev->interface != PHY_INTERFACE_MODE_10G_QXGMII) { + __set_bit(PHY_INTERFACE_MODE_2500BASEX, possible); + __set_bit(PHY_INTERFACE_MODE_SGMII, possible); + } +} + static int qca8084_config_init(struct phy_device *phydev) { int ret; + qca808x_fill_possible_interfaces(phydev); + /* Invert ADC clock edge */ ret = at803x_debug_reg_mask(phydev, QCA8084_ADC_CLK_SEL, QCA8084_ADC_CLK_SEL_ACLK,
--
2.42.0