Re: [PATCH] net: phy: at803x: Improve hibernation support on start up

From
Russell King (Oracle) <linux@armlinux.org.uk>
Date
2023-08-10 10:02:00
Reply to
Marek Vasut, 2023-08-10
On Thu, Aug 10, 2023 at 02:49:55AM +0200, Marek Vasut wrote:
On 8/10/23 00:06, Andrew Lunn wrote:
quoted
On Wed, Aug 09, 2023 at 11:34:19PM +0200, Marek Vasut wrote:
quoted
On 8/9/23 15:40, Andrew Lunn wrote:
quoted
quoted
quoted
Hm.. how about officially defining this PHY as the clock provider and disable
PHY automatic hibernation as long as clock is acquired?
Sorry, I don't know much about the clock provider/consumer, but I think there
will be more changes if we use clock provider/consume mechanism.
Less changes is not always best. What happens when a different PHY is
used?
Then the system wouldn't be affected by this AR803x specific behavior.
Do you know it really is specific to the AR803x? Turning the clock off
seams a reasonable thing to do when saving power, or when there is no
link partner.
This hibernation behavior seem specific to this PHY, I haven't seen it on
another PHY connected to the EQoS so far.
Marvell PHYs can be programmed so that RXCLK stops when the PHY
enters power down or energy-detect state, although it defaults to
always keeping the RGMII interface powered (and thus providing a
clock.)

One Micrel PHY - "To save more power, the KSZ9031RNX stops the RX_CLK
clock output to the MAC after 10 or more RX_CLK clock
cycles have occurred in the receive LPI state." which seems to imply
if EEE is enabled, then the receive clock will be stopped when
entering low-power state.

I've said this several times in this thread - I think we need a bit
in the PHY device's dev_flags to allow the MAC to say "do not power
down the receive clock" which is used by the PHY drivers to (a) program
the hardware to prevent the receive clock being stopped in situations
such as the AR803x hibernate mode, and (b) to program the hardware not
to stop the receive clock when entering EEE low power. This does seem
to be a generic thing and not specific to just one PHY - especially as
the stopping of clocks when entering EEE low power is a IEEE 802.3
defined thing.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!
Thread (32 messages) 32 messages, 6 authors, last reply 2023-12-15
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help