Thread (170 messages) 170 messages, 19 authors, 2012-09-16

[PATCH v2 02/31] arm64: Kernel booting and initialisation

From: catalin.marinas@arm.com (Catalin Marinas)
Date: 2012-08-17 13:49:43
Also in: linux-arch, lkml

On Fri, Aug 17, 2012 at 02:13:59PM +0100, Tony Lindgren wrote:
* Shilimkar, Santosh [off-list ref] [120817 03:11]:
quoted
On Fri, Aug 17, 2012 at 3:35 PM, Catalin Marinas
[off-list ref] wrote:
quoted
On Fri, Aug 17, 2012 at 10:41:10AM +0100, Santosh Shilimkar wrote:
quoted
So you expect all the secondary CPUs to be in wakeup state and probably
looping in WFE for a signal from kernel to boot. There is one issue
with this requirement though. For large CPU system, you need to reset
all the CPUs and hit this waiting loop. This will lead to large inrush
current need at bootup which may be not be supported. To avoid this
issue, secondary CPUs are kept in OFF state and then they are woken
up from kernel one by one whenever they need to be brought into the
system. This requirement should be considered.
I agree, this part will be extended. That's one method that we currently
support and suitable to the model.

The better method is the SMC standardisation that Charles Garcia-Tobin
has written (to be made available soon) and was presented at the last
Linaro Connect in HK. Given that the CPU power is usually controlled by
the secure side, we'll ask for an SMC to be issued for waking up
secondary CPUs, so it's up to the secure firmware to write the correct
hardware registers.
Thanks for the information. SMC standardization would indeed help
to overcome some of these. Will wait for that information before
next set of questions.
Yes please. If the SMC is not standardized for most calls at least,
we'll end up with a horrible mess of SoC specific calls like we
currently have. Related to that, the virtualization calls should be
also standardized so we don't end up with multiple different hypervisors
with different calls.
For hypervisor, there are two kinds of API - one meant for power
management that is pretty much the same as the SMC and another specific
to the hypervisor solution (KVM, Xen etc.). The latter is specific to
the host kernel that's running as we start it at EL2 but it's not
standardised. It would be good indeed and there are other advantages
like self-virtualisation but it needs the KVM and Xen guys to come to a
common definition.

-- 
Catalin
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help