[PATCH] arm: Add basic support for new Marvell Armada SoC family

On Sunday 20 May 2012, Russell King - ARM Linux wrote:

On Sat, May 19, 2012 at 08:45:03PM -0400, Nicolas Pitre wrote:

quoted

On Sat, 19 May 2012, Arnd Bergmann wrote:

quoted

On Saturday 19 May 2012, Jason Cooper wrote:

quoted

quoted

Board files in mach-mvebu and the rest in plat-mvebu.  That would match 
the spirit of the current split between mach-* and plat-*.

Took the words right out of my mouth.  Once DT conversions are complete,
mach-*/ would either go away, or hold legacy non-DT boards.

On a side note, I also like this because it would make converting old
board files like sheevaplug and guruplug to DT easier.  The legacy
implementation would be in mach-mvebu/ and the DT implementation would
be in plat-mvebu/.  Newcomers to the code would see a clearly defined
separation.

With that layout, where do the mach/* headers go?

I think arch/arm/plat-mvvebu/include/mach/* could work.

And try to avoid putting anything in the include/mach/ directory which
isn't needed by any code outside of arch/arm/{plat,mach}-* directory.

In other words, headers needed only for code in arch/arm/plat-mvvebu/
should be in that very same directory.

Ok, so let me make sure I got it all right:

* all *.c files that are used for multiple boards go to plat-mvebu
* all *-setup.c files go to mach-mvebu
* only headers that are used outside of {mach,plat}-mvebug go to
  plat-mvebu/include/mach
* headers used to inteface between the first two go to
  plat-mvebu/include/plat (?)

	Arnd