Hi Andrew,
Thank you for your reply.
quoted
+ u32 rgmii_tx_delay, rgmii_rx_delay;
+ u32 dly_reg, tx_dly_mask, rx_dly_mask;
+ int tx, rx;
+
+ netdev = platform_get_drvdata(pdev);
+ priv = netdev_priv(netdev);
+
+ tx = of_property_read_u32(np, "tx-internal-delay-ps", &rgmii_tx_delay);
+ rx = of_property_read_u32(np, "rx-internal-delay-ps",
+&rgmii_rx_delay);
quoted
+ if (!tx) {
The documentation for of_property_read_u32() says:
* Return: 0 on success, -EINVAL if the property does not exist,
* -ENODATA if property does not have a value, and -EOVERFLOW if the
* property data isn't large enough.
You need to handle EINVAL different to the other errors, which are real errors
and should fail the probe.
The commit message, and probably the binding needs to document what
happens when the properties are not in the DT blob. This needs to be part of
the bigger picture of how you are going to sort out the mess with existing .dts
files listing 'rgmii' when in fact they should be 'rgmii-id'.
Why can't the MAC add internal delay to RGMII? Is it necessary to add on PHY side?
quoted
+ /* Use tx-internal-delay-ps as index to configure tx delay
+ * into scu register.
+ */
+ if (rgmii_tx_delay > 64)
+ dev_warn(&pdev->dev, "Get invalid tx delay value");
Return EINVAL and fail the probe.
Agreed.
I just show warning here, because sometimes the RGMII delay value will configure at bootloader.
Therefore, it shows message and ignore the delay value when it got wrong.
I will add check for this in next version.
Thanks,
Jacky