Hi Claudiu,

-----Original Message-----
From: claudiu beznea <claudiu.beznea@tuxon.dev>
Sent: Tuesday, September 3, 2024 12:00 PM
Subject: Re: [PATCH 00/16] Add initial USB support for the Renesas RZ/G3S SoC



On 03.09.2024 13:31, Biju Das wrote:

quoted

quoted

quoted

During boot clr USB PWR READY signal in TF-A.
STR case, suspend set USB PWR READY signal in TF-A.
STR case, resume clr USB PWR READY signal in TF-A.

As I said previously, it can be done in different ways. My point was
to let Linux set what it needs for all it's devices to work. I think the way to go forward is a

maintainer decision.

quoted

I agree, there can be n number of solution for a problem.

Since you modelled system state signal (USB PWRRDY) as reset control
signal, it is reset/DT maintainer's decision to say the final word whether this signal fits in reset

system framework or not?

I was thinking:
1/ Geert would be the best to say if he considers it OK to handle this
   in Linux

I agree Geert is the right person for taking SYSTEM decisions,
since the signal is used only during state transitions
(Table 41.6.4 AWO to ALL_ON and 41.6.3 ALL_ON to AWO)

2/ if OK, then we should get approval from Ulf and Philipp on the power
   domain or reset approaches

Ok.

Cheers,
Biju