[PATCH 4/8] serial: core: sanitize RS485 delays read from device tree
From: Lino Sanfilippo <LinoSanfilippo@gmx.de>
Date: 2022-06-22 15:48:02
Also in:
linux-devicetree, linux-serial, lkml
Subsystem:
the rest, tty layer and serial drivers · Maintainers:
Linus Torvalds, Greg Kroah-Hartman, Jiri Slaby
From: Lino Sanfilippo <redacted> When setting the RS485 configuration from userspace via TIOCSRS485 the delays are clamped to 100ms. Make this consistent with the values passed in by means of device tree parameters. Signed-off-by: Lino Sanfilippo <redacted> --- drivers/tty/serial/serial_core.c | 2 ++ 1 file changed, 2 insertions(+)
diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c
index fa6acadd7d0c..2e9f90e73e62 100644
--- a/drivers/tty/serial/serial_core.c
+++ b/drivers/tty/serial/serial_core.c@@ -3382,6 +3382,8 @@ int uart_get_rs485_mode(struct uart_port *port) rs485conf->delay_rts_after_send = 0; } + uart_sanitize_serial_rs485_delays(port, rs485conf); + /* * Clear full-duplex and enabled flags, set RTS polarity to active high * to get to a defined state with the following properties:
--
2.36.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel