[PATCH 5/8] dt_bindings: rs485: Correct delay values
From: Lino Sanfilippo <LinoSanfilippo@gmx.de>
Date: 2022-06-22 15:47:58
Also in:
linux-devicetree, linux-serial, lkml
Subsystem:
open firmware and flattened device tree bindings, the rest, tty layer and serial drivers · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds, Greg Kroah-Hartman, Jiri Slaby
From: Lino Sanfilippo <redacted> The maximum allowed delay for RTS before and RTS after send is 100 ms. Adjust the documentation accordingly. Signed-off-by: Lino Sanfilippo <redacted> --- Documentation/devicetree/bindings/serial/rs485.yaml | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
index f2c9c9fe6aa7..90a1bab40f05 100644
--- a/Documentation/devicetree/bindings/serial/rs485.yaml
+++ b/Documentation/devicetree/bindings/serial/rs485.yaml@@ -22,12 +22,12 @@ properties: - description: Delay between rts signal and beginning of data sent in milliseconds. It corresponds to the delay before sending data. default: 0 - maximum: 1000 + maximum: 100 - description: Delay between end of data sent and rts signal in milliseconds. It corresponds to the delay after sending data and actual release of the line. default: 0 - maximum: 1000 + maximum: 100 rs485-rts-active-low: description: drive RTS low when sending (default is high).
--
2.36.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel