[PATCH 1/2] ARM: dts: Add the CLCD controller to Cygnus.
From: scott.branden@broadcom.com (Scott Branden)
Date: 2017-08-31 20:16:15
Also in:
linux-devicetree, lkml
Hi Eric, mode is correct, location in file needs to be moved. On 17-08-31 11:54 AM, Eric Anholt wrote:
quoted hunk ↗ jump to hunk
This doesn't yet enable it on any particular platform, as we still need a panel driver for bcm911360_entphn. Signed-off-by: Eric Anholt <redacted> --- These bits are just carving off a little bit of my 911360_entphn panel series, to reduce conflicts when rebasing (which I just did for testing pl111 changes for cygnus regressions). I'm waiting to get my current RPi panel driver in before working on the 911360 panel again. arch/arm/boot/dts/bcm-cygnus.dtsi | 10 ++++++++++ 1 file changed, 10 insertions(+)diff --git a/arch/arm/boot/dts/bcm-cygnus.dtsi b/arch/arm/boot/dts/bcm-cygnus.dtsi index 7c957ea06c66..74f73ff24aec 100644 --- a/arch/arm/boot/dts/bcm-cygnus.dtsi +++ b/arch/arm/boot/dts/bcm-cygnus.dtsi@@ -575,6 +575,16 @@ status = "disabled"; }; + clcd: clcd at 180a0000 {
please place in correct address ordered location in file
+ compatible = "arm,pl111", "arm,primecell";
+ reg = <0x180a0000 0x1000>;
+ interrupts = <GIC_SPI 155 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "combined";
+ clocks = <&axi41_clk>, <&apb_clk>;
+ clock-names = "clcdclk", "apb_pclk";
+ status = "disabled";
+ };
+
keypad: keypad at 180ac000 {
compatible = "brcm,bcm-keypad";
reg = <0x180ac000 0x14c>;