Hi Stefan,

On Thu, Feb 12, 2015 at 4:59 PM, Stefan Wahren [off-list ref] wrote:

Hi Fabio,

quoted

Fabio Estevam [off-list ref] hat am 11. Februar 2015 um 22:10
geschrieben:


On Wed, Feb 11, 2015 at 6:31 PM, Stefan Wahren [off-list ref] wrote:

quoted

quoted

I always get 0x5e5b5513 with or without your patch.

very strange. Do you have any idea why IO1_STABLE is permanent low?

On my case it is always 1.

i expected the same behavior on my hardware.

Do you use u-boot as bootloader?

Yes, I do.

quoted

quoted

Can you confirm the behavior according to your flash issue?

In my tests IO1_STABLE stays the same.

This wasn't the intension of my second question. I wanted to know about the
state of the SPI NOR flash detection process.

Does it sucessed if you apply the patch, but revert the changes in
clk_ref_set_rate() from clk-ref.c?

I don't have my mx28evk setup available at the moment, but when I
applied your patch and reverted all the changes in clk-ref.c, then the
SPI flash detection works.

I haven't tested to only reverting the changes inside
clk_ref_set_rate(), but I can do it tomorrow.

Regards,

Fabio Estevam