Re: [PATCH net-next v3 0/2] net: dsa: mxl-gsw1xx: reset the switch through reset-gpios

From
Andrew Lunn <andrew@lunn.ch>
Date
2026-11-14 15:27:15
Also in
linux-devicetree, lkml
Reply to
Joseph Telaak, 2026-11-13
Since GL's own firmware resets the switch from Linux too, I still think
a hardware reset at probe is the right fix. I'll send a v4 with the
cover letter corrected, this explained, and Sashiko's points addressed
(the silent skip with CONFIG_RESET_GPIO=n, and the repeated pulse on
probe deferral).
And this reset to clear other settings was what i was thinking about,
and how it affects backwards compatibility.

In general, a reset is good. So you should add support for it. And i
don't think there is a DT blob ABI problem. To make use of the reset
you need to change the DT blob. If you are changing the blob, you can
also change the PHY mapping at the same time.

	Andrew
Thread (10 messages) 10 messages, 5 authors, last reply 3d ago
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help