Re: [PATCH net-next v3 0/2] net: dsa: mxl-gsw1xx: reset the switch through reset-gpios

From
Andrew Lunn <andrew@lunn.ch>
Date
2026-11-13 21:06:11
Also in
linux-devicetree, lkml
Reply to
Daniel Golle, 2026-11-13
I *guess* that in this case the vendor wants to avoid using PHY
address 0 which is widely misunderstood as being the "broadcast
address" (which it is, but only in scope of AUI attachments and SFP
modules).
There are no standard for copper SFP modules, so i find it hard to
accept that SFP modules expect 0 to work as a broadcast address.
quoted
Does the driver have an implicit assumption about the addresses of the
PHYs? Should the driver actually be writing this register to put the
PHYs at the expected address?
The driver does what is described in the device tree. Ie. boot firmware
applying a non-default PHY addresses should just say so in the DT passed
to Linux imho.
And this is what i was wondering about. Is it the DT which is wrong,
or the driver?

   Andrew
Thread (10 messages) 10 messages, 5 authors, last reply 3d ago
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help