[PATCH net-next v16 0/7] net: stmmac: qcom-ethqos: add support for SCMI power domains

Add support for the firmware-managed variant of the DesignWare MAC on
the sa8255p platform. This series contains new DT bindings and driver
changes required to support the MAC in the STMMAC driver.

It also reorganizes the ethqos code quite a bit to make the introduction
of power domains into the driver a bit easier on the eye.

The DTS changes will go in separately.

Signed-off-by: Bartosz Golaszewski <redacted>
Signed-off-by: Bartosz Golaszewski <redacted>
---
Changes in v16:
- Split out the SerDes PHY patches into their own series
- only set the serdes mode for actual serdes PHY modes
- reject non-serdes PHY modes on SCMI variants
- extend some comments to unconfuse sashiko
- add a fix for an issue reported by sashiko where the tick counter would
  get reprogrammed even without the CSR clock
- Link to v15: https://patch.msgid.link/20260923-qcom-sa8255p-emac-v15-0-e82f33720737@oss.qualcomm.com (local)

Changes in v15:
- Squash patches 6 and 7 to avoid a potential hang-on-resume regression
  (Sashiko)
- Fix the AUTONEG_DISABLE early return path in forced mode (Sashiko)
- Fix Kconfig dependencies on generic power domains (Sashiko)
- Set the performance level back to 0 on unbind in the PHY driver
  (Sashiko)
- Use devm_pm_runtime_enable() where applicable
- Link to v14: https://patch.msgid.link/20260908-qcom-sa8255p-emac-v14-0-ec212b747a7d@oss.qualcomm.com (local)

Changes in v14:
- let genpd's own runtime suspend/resume callbacks own the perf state entirely
  by calling dev_pm_genpd_set_performance_state() in set_mode()
  unconditionally in the sgmii PHY driver
- drop usleep_range() from the PHY driver when setting the state as the level
  setting is already synchronous
- add missing power-domains limits for ma35d1/k3-dwmac
- fix ordering of clearing the sgmii loopback
- configure the wrapper clocks synchronously in scmi setup
- Link to v13: https://patch.msgid.link/20260713-qcom-sa8255p-emac-v13-0-119f8699ef8e@oss.qualcomm.com (local)

Changes in v13:
- Reapply OPP on speed change in the PHY driver
- Use linux/device-id/of.h instead of mod_devicetable.h
- Fix the "invalid PTP clock rate" warning on sa8255p
- Add commits necessary to allow correct link speed change with SCMI
- Link to v12: https://patch.msgid.link/20260706-qcom-sa8255p-emac-v12-0-e3ab1ecf2901@oss.qualcomm.com (local)

Changes in v12:
- Drop the power-domain-names from the SGMII PHY DT bindings
- Add missing Kconfig dependency on PM for the new SGMII PHY driver
- Link to v11: https://patch.msgid.link/20260629-qcom-sa8255p-emac-v11-0-1b7fb95b51f9@oss.qualcomm.com (local)

Changes in v11:
- Take a new approach: add a dedicated driver for the firmware-managed
  SGMII PHY and simplify changes made to the MAC driver
- Link to v10: https://patch.msgid.link/20260323-qcom-sa8255p-emac-v10-0-79302b238a16@oss.qualcomm.com (local)

Changes in v10:
- Fix unit address in DT example
- Link to v9: https://patch.msgid.link/20260316-qcom-sa8255p-emac-v9-0-c58934e76ff2@oss.qualcomm.com (local)

Changes in v9:
- Rebase on top of current linux-next again
- Link to v8: https://patch.msgid.link/20260311-qcom-sa8255p-emac-v8-0-58227bcf1018@oss.qualcomm.com (local)

Changes in v8:
- Rebase on top of recent changes in linux-next which required an
  extensive rework
- Drop partial R-b tags
- Link to v7: https://patch.msgid.link/20260306-qcom-sa8255p-emac-v7-0-d6a3013094b7@oss.qualcomm.com (local)

Changes in v7:
- Restored the correct authorship after learning git uses .mailmap for
  the --author switch
- Rebased on top of changes from Russell
- Fixed resource management issues in error paths
- Link to v6: https://lore.kernel.org/r/20260112-qcom-sa8255p-emac-v6-0-86a3d4b2ad83@oss.qualcomm.com (local)

Changes in v6:
- Fix $id value in the bindings
- Drop patch 3/8 from the series
- Update init/exit callback signatures
- Link to v5: https://lore.kernel.org/r/20251107-qcom-sa8255p-emac-v5-0-01d3e3aaf388@linaro.org (local)
- Link to v6: https://lore.kernel.org/r/20251219-qcom-sa8255p-emac-v6-0-487f1082461e@oss.qualcomm.com (local)

Changes in v5:
- Name the DT binding document after the new compatbile
- Add missing space
- Make the power-domains limits stricter
- Link to v4: https://lore.kernel.org/r/20251104-qcom-sa8255p-emac-v4-0-f76660087cea@linaro.org (local)

Changes in v4:
- Remove the phys property from the SCMI bindings
- Mark the power-domain-names property as required
- Set maxItems for power-domains to 1 for all existing bindings to
  maintain the current requirements after modifying the value in the
  top-level document
- Link to v3: https://lore.kernel.org/r/20251027-qcom-sa8255p-emac-v3-0-75767b9230ab@linaro.org (local)

Changes in v3:
- Drop 'power' and 'perf' prefixes from power domain names
- Rebase on top of Russell's changes to dwmac
- Rebase on top of even more changes from Russell that are not yet
  in next (E1vB6ld-0000000BIPy-2Qi4@rmk-PC.armlinux.org.uk)
- Link to v2: https://lore.kernel.org/all/20251008-qcom-sa8255p-emac-v2-0-92bc29309fce@linaro.org/ (local)

Changes in v2:
- Fix the power-domains property in DT bindings
- Rework the DT bindings example
- Drop the DTS patch, it will go upstream separately
- Link to v1: https://lore.kernel.org/r/20250910-qcom-sa8255p-emac-v1-0-32a79cf1e668@linaro.org (local)

---
Bartosz Golaszewski (7):
      net: stmmac: dwmac4: don't program the 1us tick counter without a CSR clock
      dt-bindings: net: qcom: document the ethqos device for SCMI-based systems
      net: stmmac: qcom-ethqos: set serdes mode before powerup
      net: stmmac: qcom-ethqos: update phy_mode to the resolved interface in mac_finish()
      net: stmmac: qcom-ethqos: reuse the address of ethqos_emac_driver_data
      net: stmmac: qcom-ethqos: factor out linux-level setup into a separate function
      net: stmmac: qcom-ethqos: add support for sa8255p

 .../bindings/net/allwinner,sun7i-a20-gmac.yaml     |   3 +
 .../bindings/net/altr,socfpga-stmmac.yaml          |   3 +
 .../bindings/net/amlogic,meson-dwmac.yaml          |   3 +
 .../devicetree/bindings/net/eswin,eic7700-eth.yaml |   3 +
 .../devicetree/bindings/net/intel,dwmac-plat.yaml  |   3 +
 .../bindings/net/loongson,ls1b-gmac.yaml           |   3 +
 .../bindings/net/loongson,ls1c-emac.yaml           |   3 +
 .../bindings/net/nuvoton,ma35d1-dwmac.yaml         |   3 +
 .../devicetree/bindings/net/nxp,dwmac-imx.yaml     |   3 +
 .../devicetree/bindings/net/nxp,lpc1850-dwmac.yaml |   3 +
 .../devicetree/bindings/net/nxp,s32-dwmac.yaml     |   3 +
 .../devicetree/bindings/net/qcom,ethqos.yaml       |   3 +
 .../bindings/net/qcom,sa8255p-ethqos.yaml          | 107 +++++++++
 .../devicetree/bindings/net/renesas,rzn1-gmac.yaml |   3 +
 .../bindings/net/renesas,rzv2h-gbeth.yaml          |   3 +
 .../devicetree/bindings/net/rockchip-dwmac.yaml    |   3 +
 .../devicetree/bindings/net/snps,dwmac.yaml        |   5 +-
 .../bindings/net/sophgo,cv1800b-dwmac.yaml         |   3 +
 .../bindings/net/sophgo,sg2044-dwmac.yaml          |   3 +
 .../devicetree/bindings/net/spacemit,k3-dwmac.yaml |   3 +
 .../bindings/net/starfive,jh7110-dwmac.yaml        |   3 +
 .../devicetree/bindings/net/stm32-dwmac.yaml       |   3 +
 .../devicetree/bindings/net/tesla,fsd-ethqos.yaml  |   3 +
 .../devicetree/bindings/net/thead,th1520-gmac.yaml |   3 +
 .../bindings/net/toshiba,visconti-dwmac.yaml       |   3 +
 MAINTAINERS                                        |   1 +
 .../ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c    | 265 +++++++++++++++++----
 drivers/net/ethernet/stmicro/stmmac/dwmac4_core.c  |   9 +-
 28 files changed, 402 insertions(+), 54 deletions(-)
---
base-commit: 07d73541fde12a6c05f230509142a66e6c8751eb
change-id: 20250704-qcom-sa8255p-emac-8460235ac512

Best regards,
-- 
Bartosz Golaszewski [off-list ref]