Am 30.06.24 um 11:15 schrieb Chen-Yu Tsai:

On Sun, Jun 30, 2024 at 5:10 PM Jacobe Zang [off-list ref] wrote:

quoted

Hi Stefan,

quoted

quoted

WiFi modules often require 32kHz clock to function. Add support to
enable the clock to PCIe driver.

the low power clock is independent from the host interface like PCIe. So
the clock handling should move to the common code. Sorry, not i cannot
give a good suggestion, what's the best place for this.

I think the clock is used by the PCIe device so enable it in this file. Also I checked
use of clock which in spi[0] or sdio[0] device was enabled similarly to this.

[0] https://lore.kernel.org/all/20210806081229.721731-4-claudiu.beznea@microchip.com/ (local)

You're looking at the wrong driver. For brcmfmac, the lpo clock is toggled
by the MMC pwrseq code. And for the Bluetooth side (where it really matters)
for UARTs, it is in drivers/bluetooth/hci_bcm.c. and documented in the
binding Documentation/devicetree/bindings/net/broadcom-bluetooth.yaml

Thanks for clarifying. So this change handles the PCIe case without
bluetooth. For USB the clock control doesn't make sense.

Sorry for the noise

ChenYu