[PATCH v4 3/4] dt-bindings: net: xilinx_axienet: add pcs-handle attribute
From: Andy Chiu <hidden>
Date: 2022-03-21 15:27:26
Also in:
linux-devicetree
Subsystem:
networking drivers, open firmware and flattened device tree bindings, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document the new pcs-handle attribute to support connecting to an external PHY in SGMII or 1000Base-X modes through the internal PCS/PMA PHY. Signed-off-by: Andy Chiu <redacted> Reviewed-by: Greentime Hu <greentime.hu@sifive.com> --- Documentation/devicetree/bindings/net/xilinx_axienet.txt | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/net/xilinx_axienet.txt b/Documentation/devicetree/bindings/net/xilinx_axienet.txt
index b8e4894bc634..ba720a2ea5fc 100644
--- a/Documentation/devicetree/bindings/net/xilinx_axienet.txt
+++ b/Documentation/devicetree/bindings/net/xilinx_axienet.txt@@ -26,7 +26,8 @@ Required properties: specified, the TX/RX DMA interrupts should be on that node instead, and only the Ethernet core interrupt is optionally specified here. -- phy-handle : Should point to the external phy device. +- phy-handle : Should point to the external phy device if exists. Pointing + this to the PCS/PMA PHY is deprecated and should be avoided. See ethernet.txt file in the same directory. - xlnx,rxmem : Set to allocated memory buffer for Rx/Tx in the hardware
@@ -68,6 +69,11 @@ Optional properties: required through the core's MDIO interface (i.e. always, unless the PHY is accessed through a different bus). + - pcs-handle: Phandle to the internal PCS/PMA PHY in SGMII or 1000Base-X + modes, where "pcs-handle" should be preferably used to point + to the PCS/PMA PHY, and "phy-handle" should point to an + external PHY if exists. + Example: axi_ethernet_eth: ethernet@40c00000 { compatible = "xlnx,axi-ethernet-1.00.a";
--
2.34.1