Re: [PATCH net-next 00/13] Add NXP SJA1110 support to the sja1105 DSA driver
From: Andrew Lunn <andrew@lunn.ch>
Date: 2021-05-25 02:03:56
There are some integrated NXP PHYs (100base-T1 and 100base-TX). Their initialization is handled by their own PHY drivers, the switch is only concerned with enabling register accesses to them, by registering two MDIO buses. PHY interrupts might be possible, however I believe that the board I am working on does not have them wired, which makes things a bit more difficult to test.
In general, internal PHYs have an internal interrupt controller, often
in the switch register space. There then might be one interrupt from
the switch to the host. It could be this one interrupt is missing on
your board. But this is also quite common with mv88e6xxx boards. So i
added code to poll the interrupt bit, i think 10 times per
second. Polling one bit 10 times a second is more efficient than
having phylib poll each PHY every second when it needs to read a
number of registers. And the latency is better.
Andrew