Re: [PATCH 2/4] dt-bindings: net: Add bindings for Qualcomm QCA807x

On Wed, Dec 23, 2020 at 01:56:33AM +0100, Andrew Lunn wrote:

quoted

+  gpio-controller: true
+  "#gpio-cells":
+    const: 2
+
+  qcom,single-led-1000:
+    description: |
+      If present, then dedicated 1000 Mbit will light up for 1000Base-T.
+      This is a workround for boards with a single LED instead of two.
+    type: boolean
+
+  qcom,single-led-100:
+    description: |
+      If present, then dedicated 1000 Mbit will light up for 100Base-TX.
+      This is a workround for boards with a single LED instead of two.
+    type: boolean
+
+  qcom,single-led-10:
+    description: |
+      If present, then dedicated 1000 Mbit will light up for 10Base-Te.
+      This is a workround for boards with a single LED instead of two.
+    type: boolean

Sorry, but no. Please look at the work being done for allow PHY LEDs
to be controlled via the LED subsystem. 

quoted

+  qcom,tx-driver-strength:
+    description: PSGMII/QSGMII TX driver strength control.
+    $ref: /schemas/types.yaml#/definitions/uint32
+    enum: [0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12]

Please use the actual values here, and have the driver convert to the
value poked into the register. So the property would be
qcom,tx-driver-strength-mv and it would have the value 220 for
example.

The LED binding has properties for specifying the current already. And 
it's max current which is the h/w property where as anything less is 
just software configuration (IOW, doesn't belong in DT).