Hi Vladimir,

On Friday, 30 October 2020, 19:24:47 CET, Vladimir Oltean wrote:

On Thu, Oct 22, 2020 at 12:17:48PM +0200, Christian Eggers wrote:

quoted

I tried to study the effect of setting the ocmode bit on the KSZ either to
master or to slave. The main visible change is, that some PTP message
types
are be filtered out on RX:
- in "master" mode, "Sync" messages from other nodes will not be received
(but everything else like "Announce" seem to work)
- in "slave" mode, "Delay_Req" messages from other nodes will not be
received

Could you dump the contents of your REG_PTP_MSG_CONF2 register?

runtime register value is 0x1004 (matches default value from the data sheet).
The Linux driver doesn't touch this register. Below is a dump of all PTP
related (global) registers.

regards
Christian

    KSZ9563 (Ethernet switch)

      Global

        IEEE 1588 PTP
        CLKCTRL      0002      SWFA         enabled        CLKSADJ        NOP              PTPSD        subtract
                               CLKREAD      NOP            CLKWRITE       NOP              CLKCADJ      disabled
                               EN           enabled        RESET          normal
        RTCCP        0002      PHASE        16ns
        RTCNS        17D72FF0  NANOSECONDS    399978480
        RTCS         00000023  SECONDS               35
        RTCSUBNS     00000000  RATEDIR      subtract       TEMPADJ        permanent
                               SUBNS                  0
        RTCTMPADJ    00000000  CYCLES                 0
        MSGCFG1      007D      MODEEN       enabled        IEEE802.3      enabled          UDPv4        enabled
                               UDPv6        enabled        TCMODE         P2P              OCMODE       slave
        MSGCFG2      1004      UNICASTEN    both           ALTMASTER      disabled         PRIOTX       event only
                               CHKSYNFU     disabled       CHKDLY         disabled         CHKPDLY      disabled
                               DROP         disabled       CHKDOM         disabled         IPv4CHKSUM   calc
        DOMVER       0200      VERSION      2              DOMAIN            0
        UNITIDX      00000000  GPIO_IDX     GPIO_1         TS_IDX         Unit 0           TRIG_IDX     Unit 0