On Sun, Jul 29, 2018 at 04:03:10PM +0200, Hauke Mehrtens wrote:

On 07/25/2018 05:28 PM, Andrew Lunn wrote:

quoted

quoted

+	/* Make sure the firmware of the embedded GPHY is loaded before,
+	 * otherwise they will not be detectable on the MDIO bus.
+	 */
+	of_for_each_phandle(&it, err, np, "lantiq,phys", NULL, 0) {
+		phy_np = it.node;
+		if (phy_np) {
+			struct platform_device *phy = of_find_device_by_node(phy_np);
+
+			of_node_put(phy_np);
+			if (!platform_get_drvdata(phy))
+				return -EPROBE_DEFER;
+		}
+	}

Is there a device tree binding document for this somewhere?

   Andrew

No, but I will create one.

I am also not sure iof this is the correct way of doing this.

We first have to load the FW into the Ethernet PHY though some generic
SoC registers and then we can find it normally on the MDIO bus and
interact with it like an external PHY on the MDIO bus.

Hi Hauke

It look sensible so far, but it would be good to post the PHY firmware
download code as well. Lets see the big picture, then we can decide if
there is a better way.

    Andrew