Re: Micrel Phy KSZ8031 clock select setting in dts

On 20/06/16, Andrew Lunn wrote:

quoted

&fec1 {
	pinctrl-names = "default";
	pinctrl-0 = <&pinctrl_enet1>;
	phy-mode = "rmii";
	micrel,rmii-reference-clock-select-25-mhz;
	clocks,rmii-ref;

You are adding phy properties, not MAC properties. Please put them in
the phy node.

yes, you are right. I fixed this and added the clock like sascha and
sergei proposed. (thx to you all)

my dts node now looks like this:

&fec1 {
	pinctrl-names = "default";
	pinctrl-0 = <&pinctrl_enet1>;
	phy-mode = "rmii";
	status = "okay";

	mdio {
		#address-cells = <1>;
		#size-cells = <0>;

		ethphy0: ethernet-phy@0 {
			compatible = "micrel,ksz8031";
			micrel,rmii-reference-clock-select-25-mhz;
			clocks = <&mdc>;
			clock-names = "rmii-ref";
			phy-handle = <&ethphy0>;
			reg = <0>;
		};

	};

	mdc: rmii-ref {
		#clock-cells = <0>;
		compatible ="fixed-clock";
		clock-frequency = <50000000>;
	};
};


But I also needed to invert the behavior of KSZPHY_RMII_REF_CLK_SEL in
the micrel.c driver to get everything working with my revison of Micrel Phy.

If I understood you right this should not be necessary. So something in
dts is still wrong.

diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index 7f4e042..198a24f 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c

@@ -181,10 +181,14 @@ static int kszphy_rmii_clk_sel(struct phy_device *phydev, bool val)
 		return ctrl;
 	}
 
-	if (val)
+	if (val){
+		printk(KERN_DEBUG "if kszphy_rmii_clk_sel val=0x%x \n", val);
 		ctrl |= KSZPHY_RMII_REF_CLK_SEL;
-	else
-		ctrl &= ~KSZPHY_RMII_REF_CLK_SEL;
+	}
+	else{
+		printk(KERN_DEBUG "else kszphy_rmii_clk_sel val=0x%x \n", val);
+		ctrl |= KSZPHY_RMII_REF_CLK_SEL;
+	}

Best Regards,

Oliver