[PATCH] rt2x00: Use ops name instead of device name

Recently, someone complained that they see the PCI address of a device
in the interrupts file instead of the device name.

19:   73474106          0   IO-APIC-fasteoi   ata_piix, uhci_hcd:usb6, 0000:05:01.0

From lspci:

05:01.0 Network controller: RaLink RT2561/RT61 rev B 802.11g
  Subsystem: D-Link System Inc AirPlus G DWL-G510 Wireless Network Adapter (Rev.C)
  Flags: bus master, slow devsel, latency 32,
  IRQ 19  Memory at f9100000 (32-bit, non-prefetchable) [size=32K]
  Capabilities: <access denied>
  Kernel driver in use: rt61pci
  Kernel modules: rt61pci

Investigating this, it seems to be the result of the pci_name() used in
rt2x00pci_probe().

Since the struct rt2x00_ops records the module name for the device as
well as the ops, it would make more sense to show that in the interrupt
output instead.

Signed-off-by: Steven Rostedt <rostedt@goodmis.org>

diff --git a/drivers/net/wireless/rt2x00/rt2x00pci.c b/drivers/net/wireless/rt2x00/rt2x00pci.c
index ace0b66..06575dc 100644
--- a/drivers/net/wireless/rt2x00/rt2x00pci.c
+++ b/drivers/net/wireless/rt2x00/rt2x00pci.c

@@ -284,7 +284,7 @@ int rt2x00pci_probe(struct pci_dev *pci_dev, const struct pci_device_id *id)
 	rt2x00dev->ops = ops;
 	rt2x00dev->hw = hw;
 	rt2x00dev->irq = pci_dev->irq;
-	rt2x00dev->name = pci_name(pci_dev);
+	rt2x00dev->name = ops->name;
 
 	if (pci_is_pcie(pci_dev))
 		rt2x00_set_chip_intf(rt2x00dev, RT2X00_CHIP_INTF_PCIE);