Re: NAPI, rx_no_buffer_count, e1000, r8169 and other actors

Very sorry, forgot dmesg
[    3.070955] r8169 Gigabit Ethernet driver 2.2LK-NAPI loaded
[    3.070972] ACPI: PCI Interrupt 0000:07:00.0[A] -> GSI 21 (level, low) ->
IRQ 21
[    3.071582] eth0: RTL8110s at 0xf8894000, 00:18:f8:0b:46:a6, XID 04000000
IRQ 21


On Sun, 15 Jun 2008 22:57:10 +0200, Francois Romieu wrote

Denys Fedoryshchenko [off-list ref] :
[...]

quoted

Third host r8169 (PCI! This is important, seems i am running out of PCI
capacity), 400Mbit/s rx+tx summary load, e1000e interface also - around

400 rx + 400 tx or 200 rx + 200 tx ?
Can you specify the packet rate and the cpu ?

quoted

200Mbps load. What is worrying me - interrupts rate, it seems generated by
realtek card... is there any way to drop it down? 

Also some packetloss, around 0.0005% (i prefer to have clear zero :-)) ). No
nat, no shapers, same kernel configuration.

Can you send an ethtool -S (+ ifconfig) of the 8169 if it misses 
packets as well as the lines of dmesg which relate to the r8169 
driver ?

-- 
Ueimor
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

--
Denys Fedoryshchenko
Technical Manager
Virtual ISP S.A.L.