Re: Mac address in the DT

Dear smitha.vanga@wipro.com,

In message [ref] you wrote:

quoted

Setenv set_mac 'cp 0xffec0000 0x100000 1024;fdt addr 0xc00000 8192;fdt set=

 /soc8272@f0000000/ethernet@24000 mac-address "[00 44 00 55 00 66]";erase 0x=
ffec0000 0xffec4000;cp 0xc00000 0xffec0000 1024;bootm 0xfe060000 - 0xffec000=
0'

quoted

run set_mac

For the above command I want to replace the mac address with the ethaddr> How
do I do that. I tried $ethaddr but I get extra : characters.

Why would you do that at all?  U-Boot will run fdt_fixup_ethernet()
for all (at least AFAICT) supported architectures, which will replace 
"mac-address" and "local-mac-address" for all "ethernet?" interfaces
in the device tree for which a corresponding "ethadd" / "eth?addr"
environment variable is set.

No additional actions are needed.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
"One day," said a dull voice from down below, "I'm going to  be  back
in  form again and you're going to be very sorry you said that. For a
very long time. I might even go so far as to make even more Time just
for you to be sorry in."              - Terry Pratchett, _Small Gods_