Re: Kernel boot up

On 08/25/2011 02:57 AM, smitha.vanga@wipro.com wrote:

Hi Scott,

I am currently trying to bring up 2.6.39 kernel on a target based on MPC8247
Processor, using the attched .dts  file . I get the below logs while the
kernel is booting.
I see that the unflattening of the device tree and the initial loading
of the kernel and ramdisk file system is happening correctly. Can you
point me where exactly I can look for this issue. I am attaching the
.config and .dts file I am using.

Which error are you referring to?

of-flash ff800000.flash: do_map_probe() failed

What kind of flash chip do you have?  Does the node in the device tree
accurately describe it (four interleaved 8-bit chips that only do JEDEC
and not CFI)?

PPP generic driver version 2.4.2
PPP Deflate Compression module registered
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky [off-list ref]
eth0: fs_enet: 00:00:00:00:00:00
eth1: fs_enet: 00:00:00:00:00:00

These MAC addresses should have been set in the device tree.  If you're
using U-Boot, it should be doing the fixup.

Populating /dev using udev: /sbin/udevd: '/lib/libc.so.6' library
contains unsup
ported TLS
/sbin/udevd: '/lib/libc.so.6' library contains unsupported TLS
/sbin/udevd: can't load library 'libc.so.6'
FAIL
/sbin/udevstart: '/lib/libc.so.6' library contains unsupported TLS
/sbin/udevstart: '/lib/libc.so.6' library contains unsupported TLS
/sbin/udevstart: can't load library 'libc.so.6'
FAIL

This is a problem with the root filesystem, not the kernel.

-Scott