February 2008

332 messages across 102 threads. The 100 most recently active threads.

LastThreadReplies
Friday 29 February
Re: Severe slowdown with LVM on RAID, alignment problem?
Michael Guntsche
2
Re: Understanding bonnie++ results
Franck Routier
1
Understanding bonnie++ results
Franck Routier
3
Re: Severe slowdown with LVM on RAID, alignment problem?
Michael Guntsche
none
Severe slowdown with LVM on RAID, alignment problem?
Michael Guntsche
none
Thursday 28 February
2x6 or 3x4 raid10 arrays ?
Franck Routier
6
Corrupted RAID 50 (aparently?) array. Help needed.
unknown sender
1
how to use mkfs.ext3 "stride=" on LVM on RAID correctly?
Tomasz Chmielewski
2
Corrupted RAID 50 (aparently?) array. Help needed.
unknown sender
none
Corrupted RAID 50 (aparently) array. Help needed.
Nicolas Mella
none
Corrupted RAID 50 (aparently?) array. Help needed.
Nicolas Mella
none
Corrupted RAID 50 (aparently?) array. Help needed.
unknown sender
none
[PATCH] The md RAID10 resync thread could cause a md RAID10 array deadlock
K.Tanaka
none
Wednesday 27 February
Re: very poor ext3 write performance on big filesystems?
Andreas Dilger
1
Is 'fd' partition type of any use ?
Franck Routier
1
md3: unsupported reshape (reduce disks) required - aborting
Bernd Schubert
1
Article aimed at general audience
Bruce Miller
1
Tuesday 26 February
Re: suns raid-z / zfs
Neil Brown
3
Re: Very small internal bitmap after recreate
Ralf Müller
1
mdadm 2.6 creates slow RAID 5 while mdadm 2.5.6 rocks
Hubert Verstraete
3
Re: raid1 error handling and faulty drives
Neil Brown
1
Monday 25 February
board/controller recommendations?
Dexter Filmore
5
RAID5 to RAID6 reshape?
Beolach
25
Kernel panic on RAID1 root after upgrade
Richard Ray
none
mismatch_cnt != 0
Justin Piszcz
7
Further clarification of the sync_action check behavior.
Harrell, Thomas
1
Sunday 24 February
RAID10 far (f2) read throughput on random and sequential / read-ahead
Nat Makarevitch
2
Saturday 23 February
Odd performance observation for RAID0
Joe Landman
none
Friday 22 February
Increased Reliability by using Raid
Pete/Piet Delaney
none
MD sysfs/kobject issues in SAN environment.
unknown sender
none
Thursday 21 February
How many drives are bad?
Norman Elton
12
Re: How many drives are bad?
Neil Brown
none
Wednesday 20 February
RE: How many drives are bad?
Guy Watkins
none
Tuesday 19 February
Linux Software RAID 5 + XFS Multi-Benchmarks / 10 Raptors Again
Justin Piszcz
1
Monday 18 February
HDD errors in dmesg, but don't know why...
Steve Fairbairn
2
Re: suns raid-z / zfs
Neil Brown
1
Re: Create Raid6 with 1 missing member fails
Neil Brown
none
Re: RAID5 to RAID6 reshape?
Neil Brown
none
Re: RAID5 to RAID6 reshape?
Neil Brown
none
Sunday 17 February
suns raid-z / zfs
Keld Jørn Simonsen
none
Create Raid6 with 1 missing member fails
Sevrin Robstad
none
Friday 15 February
[BUG] OOPS 2.6.24.2 raid5 write with ioatdma
Laurent CORBES
2
Thursday 14 February
Re: 2.6.24-rc6 reproducible raid5 hang
Tim Southerwood
1
Re: transferring RAID-1 drives via sneakernet
Jeff Breidenbach
none
Wednesday 13 February
transferring RAID-1 drives via sneakernet
Jeff Breidenbach
6
Got raid10 assembled wrong - how to fix?
George Spelvin
1
[BUGREPORT] The kernel thread for md RAID10 could cause a md RAID10 array deadlock
K.Tanaka
none
Tuesday 12 February
patch for raid10,f>1 to operate like raid0
Keld Jørn Simonsen
none
Monday 11 February
[PATCH] Use new sb type
Jan Engelhardt
8
my io testing scripts
Keld Jørn Simonsen
none
howto on performance
Keld Jørn Simonsen
none
3ware and dmraid - duplicate serial numbers (!)
Ask Bjørn Hansen
1
Sunday 10 February
howto and faq
Keld Jørn Simonsen
4
Re: when is a disk "non-fresh"?
Neil Brown
2
RAID5 how chage chunck size from 64 to 128, 256 ? is it possible ?
Andreas-Sokov
3
Saturday 9 February
kernel BUG at drivers/md/md.c:5145!
Janos Haar
none
Re: Re[2]: mdadm 2.6.4 : How i can check out current status of reshaping ?
Neil Brown
4
Friday 8 February
Any inexpensive hardware recommendations for PCI interface cards?
Steve Fairbairn
8
ICH10 support
Mike Myers
none
Re: Deleting mdadm RAID arrays
Neil Brown
5
raid5: two writing algorithms
Keld Jørn Simonsen
4
Thursday 7 February
Re: when is a disk "non-fresh"?
Neil Brown
1
using update-initramfs: how to get new mdadm.conf into the /boot? Or is it XFS?
Moshe Yudkowsky
8
[PATCH] Dynamic RAID Stripe Cache Size
Yuri Tikhonov
none
Re: recommendations for stripe/chunk size
Wolfgang Denk
4
draft howto on making raids for surviving a disk crash
Keld Jørn Simonsen
13
Re: recommendations for stripe/chunk size
Wolfgang Denk
none
Re: recommendations for stripe/chunk size
Neil Brown
none
Re: recommendations for stripe/chunk size
Neil Brown
none
Re: recommendations for stripe/chunk size
Neil Brown
none
Re: raid10 on three discs - few questions.
Neil Brown
none
Wednesday 6 February
raid1 or raid10 for /boot
Keld Jørn Simonsen
5
Re: which raid level gives maximum overall speed? (raid-10,f2 vs. raid-0)
Janek Kozicki
none
Re: raid10 on three discs - few questions.
Bill Davidsen
none
recommendations for stripe/chunk size
Keld Jørn Simonsen
2
Re: Deleting mdadm RAID arrays
Neil Brown
4
Re: raid10 on three discs - few questions.
Neil Brown
5
FW: Disk failure during grow, what is the current state.
Steve Fairbairn
1
Disk failure during grow, what is the current state.
Steve Fairbairn
1
Re: Deleting mdadm RAID arrays
Neil Brown
1
Deleting mdadm RAID arrays
Marcin Krol
11
RAID needs more to survive a power hit, different /boot layout for example (was Re: draft howto on making raids for surviving a disk crash)
Moshe Yudkowsky
24
which raid level gives maximum overall speed? (raid-10,f2 vs. raid-0)
Janek Kozicki
8
Tuesday 5 February
Re: mdadm 2.6.4 : How i can check out current status of reshaping ?
Neil Brown
1
Monday 4 February
non-fresh: what?
Dexter Filmore
1
raid1 and raid 10 always writes all data to all disks?
Keld Jørn Simonsen
3
Re: In this partition scheme, grub does not find md information?
Neil Brown
3
Re: Linux md and iscsi problems
Neil Brown
1
mdadm 2.6.4 : How i can check out current status of reshaping ?
Andreas-Sokov
none
Re: Re[2]: problem with spare, acive device, clean degrated, reshaip RADI5, anybody can help ?
Neil Brown
none
Re: problem with spare, acive device, clean degrated, reshaip RADI5, anybody can help ?
Neil Brown
2
Re: /dev/sdb has different metadata to chosen array /dev/md1 0.91 0.90.
Neil Brown
none
Sunday 3 February
raid10 on three discs - few questions.
Janek Kozicki
none
RAID 1 and grub
Richard Scobie
5
Re: raid problem: after every reboot /dev/sdb1 is removed?
Bill Davidsen
none
Re: assemble vs create an array.......
Neil Brown
1
Saturday 2 February
Assemble Same RAID0 More than Once?
AndrewL733
none
raid problem: after every reboot /dev/sdb1 is removed?
Berni
3
/dev/sdb has different metadata to chosen array /dev/md1 0.91 0.90.
Andreas-Sokov
none
mdadm: /dev/md1: Cannot reshape array without increasing size (yet).
Andreas-Sokov
none
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help