On 09/12/2023 16:41, Biju Das wrote:
quoted
Why disabling? Drop all statuses from all your binding examples.
quoted
quoted
Where are gpio-controller and cells? For this node and for parent?
Why this example is incomplete?
Currently I don't see any driver is using this compatible other than
MFD.
Open the MFD so you will see it...
Actually, found the driver and tested GPIOs,
For input gpio, I can see the sd1_pwr_sel values are
toggled during card insert/removal.
For outout gpio,
System is entering into reset mode, if I set output-low in DT. So set
Init state as output-high to avoid reset.
drivers/pinctrl/pinctrl-da9062.c
Anyway there is a GPIO child node and driver which binds to it. What's
its purpose in such case?
Best regards,
Krzysztof