Re: [RFC] QT1070: change the trigger mode of QT1070

Hello, Dmitry

On 5/7/2012 3:04 PM, Dmitry Torokhov wrote:

Hi Bo,

On Mon, May 07, 2012 at 10:27:33AM +0800, Bo Shen wrote:

quoted

The default trigger mode of QT1070 is IRQF_TRIGGER_LOW,
Using TRQF_TRIGGER_FALLING to replace IRQF_TRIGGER_LOW | IRQF_ONESHOT.

Why don't you set up IRQ the way you want in board code instead of
implementing workarounds in the driver?

The QT1070 will generate a falling edge interrupt if any valid data 
coming. The workaround is only for the boarding that can handle edge 
interrupt but cannot distinguish rising and falling.
So I think put this trigger set up code to board code will make thing 
more complex.

Thanks.

Best Regards,
Josh Wu