On Wed, Sep 22, 2004 at 10:09:03AM -0700, Dave wrote:

On Wed, 22 Sep 2004 08:59:06 -0700, Dave [off-list ref] wrote:

quoted

On Tue, 21 Sep 2004 19:06:14 -0700, Jeremy Higdon <jeremy@sgi.com > wrote:

quoted

On Tue, Sep 21, 2004 at 02:16:46PM -0700, Dave wrote:

quoted

After getting that working I noticed that the last_ctl value gets
changed back by the LIBATA core and the Vitesse SATA driver depends on
the previous value in order to unmask the interrupt. So it seems that
there's no need to set/unset the interrupt masks in the first place if
we set the CTL register with ATA_NIEN directly, which I believe is
probably the way LIBATA intended the driver to do. After doing that
everything seems to be working great. So I suppose
vsc_intr_mask_update() is no longer needed probably.

The chip specification says not to set it that way.  Are you using
the chip in DPA mode or PCI-IDE mode?  The driver assumes the former.  I
don't know why anyone would use the chip in PCI-IDE mode.

Hmmm...I did not see it in the spec. Can you provide the pointer to
the spec please? Thanks! I am using it in DPA mode. If you are in
PCI-IDE mode, all registers would reside in different BARs and the
card wouldn't work anyways with that driver. I copied the section from
sata_svw.c. And it seems to work just fine. I don't see how the
previous method would be working. In vsc_sata_tf_load a compare is
done between the tf->ctl and the ap->last_ctl. However, if I do it
with the current method, I continue to see ap->last_ctl with ATA_NIEN
cleared even though the previous value was set. Therefore the driver
never unmask the IDE interrupt and thus hang.  What happened was, host
1, dev 0 was probed and was okay. Then it attempted to probe host 1,
dev 1, which of course does not exist, so at exit, ata_irq_on() was
called. With that the last_ctl was reset with ATA_NIEN cleared.
Therefore when the driver does the compare of ctl with last_ctl, it
sees no difference, and therefore interrupt mask never changed.

I see what you mean by the spec regarding the ATA_NIEN bit. ATA_NIEN
is reserved bit in DPA mode. I guess it still works. But to do the
things the right way now this becomes a problem since as I mentioned
above, libata-core can change the last_ctl value without the driver's
knowledge. So really we cannot always depend on last_ctl to be the
last_ctl the driver has set. I'm not exactly sure yet why the driver
works on IA in the current state. Everything tells me it shouldn't....
Unless there's something that I'm suppose to configure to force it not
probe device 1 since in SATA there's never device 1?

I can tell you that it works fine on our Altix (IA64 Numa) boxes with
1 - 4 drives attached.  I don't recall exactly how we tell libata that
there is only one device per port -- there must be a parameter somewhere :-)
I do remember that we had to explicitly tell the IDE layer about that,
for the IDE version of the driver in lk2.4.

jeremy