Re: [PATCH v2 1/4] mfd: add LM3533 lighting-power core driver

On Thu, May 03, 2012 at 01:28:03PM +0200, Johan Hovold wrote:

On Thu, May 03, 2012 at 11:38:48AM +0100, Mark Brown wrote:

quoted

I'd expect you can drop these log messages, if there's stuff like this
missing we should add it to regmap.  At the minute the regmap logging is
via trace points rather than debug logs as you can leave them enabled
all the time.

If such debugging is added to regmap we still need a way to enable them
per driver (or rather regmap) to not clutter the logs.

This is one of the reasons why we currently use tracepoints (they just
don't have this issue as they're trivial to filter), though
adding some sort of infrastructure for it ought not to be too difficult
even if it's just at the regmap level.

These three dev_dbg statements are extremely useful during debugging /
development especially in combination with the other dynamic printks in
these drivers.

I'd actually prefer just keeping them for now.

OTOH the whole point in having stuff like this is to factor out repeated
code like this so if the infrastructure isn't working we should fix
that.

quoted

Might also be worth moving some of the sysfs stuff to live with the
relevant drivers.

Which attributes do you have in mind?

Pretty much all of those on the MFD.

The boost_freq and boost_ovp affect both backlight devices (i.e. cannot
be set separately) and as such belong in the parent driver IMO.

Same with the output_hvled{1..2}, output_lvled{1..5} attributes. The
chip has four logical LEDs ("control banks") but five low-voltage output
sinks. The five output_lvled attributes determine the mapping and as
such belong in the parent driver. The two logical backlight devices can
likewise be used to control either or both high-voltage outputs and
belong in the parent driver for the same reasons.

Actually, the other question I had but forgot to ask (or I think punted
on for your response) was why these are in sysfs at all - things like
which things are connected to the backlight are going to be a property
of the board design so should be defined by the machine not tweaked from
userspace.