On 16/03/21 12:00AM, Pratyush Yadav wrote:

+Cc mtd list

Hi,

On 15/03/21 05:45PM, Kuldeep Singh wrote:

quoted

Convert the Freescale DSPI binding to DT schema format using json-schema.

Signed-off-by: Kuldeep Singh <redacted>
---
Hi Rob,
This patch is checked with following commands with no warnings observed.
make distclean; make allmodconfig;
make dt_binding_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/spi/fsl,spi-fsl-dspi.yaml;
make dtbs_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/spi/fsl,spi-fsl-dspi.yaml

When I add the "fsl,spi-cs-sck-delay" property under the flash@0 node in 
the example and run dt_binding_check, I see the below error:

  /home/pratyush/src/linux/Documentation/devicetree/bindings/spi/fsl,spi-fsl-dspi.example.dt.yaml: flash@0: 'fsl,spi-cs-sck-delay' does not match any of the regexes: '^partition@', 'pinctrl-[0-9]+'
     From schema: /home/pratyush/src/lin/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml

I am trying to solve a similar problem for the Cadence QSPI controller 
binding and I wonder what the best solution for this is. The obvious one 
would be to add these properties to jedec,spi-nor.yaml. I haven't 
managed to come up with any other solution to this problem.

Rob, all, any suggestions on how to best model this?

Ping. Any ideas?

-- 
Regards,
Pratyush Yadav
Texas Instruments Inc.