Re: [PATCH v6 1/7] dt-bindings: usb: hd3ss3220 device tree binding document

Hi

quoted

+Required properties:
+ - compatible: Must be "ti,hd3ss3220".
+ - reg: I2C slave address, must be 0x47 or 0x67 based on ADDR pin.
+ - interrupts: <a b> where a is the interrupt number and b represents an
+   encoding of the sense and level information for the interrupt.
+
+Required sub-node:
+ - connector : The "usb-c-connector" attached to the hd3ss3220 chip. The

s/connector :/connector:/

Maybe it is for alignment ?

According to the connector/usb-connector.txt, should the connector node
have ports, port@1 and an endpoint nodes like below?

"ports" is needed if it has multiple "port",
otherwise, single port is allowed from OF-graph point of view.

Thank you for your help !!
Best regards
---
Kuninori Morimoto