[PATCH v2 01/25] mtd: nand: qcom: fix config error for BCH
From: Abhishek Sahu <hidden>
Date: 2017-07-19 11:48:53
Also in:
linux-arm-msm, lkml, stable
Subsystem:
arm/qualcomm mailing list, memory technology devices (mtd), nand flash subsystem, the rest · Maintainers:
Miquel Raynal, Richard Weinberger, Vignesh Raghavendra, Linus Torvalds
The configuration for BCH is not correct in the current driver.
The ECC_CFG_ECC_DISABLE bit defines whether to enable or disable the
BCH ECC in which
0x1 : BCH_DISABLED
0x0 : BCH_ENABLED
But currently host->bch_enabled is being assined to BCH_DISABLED.
Fixes: c76b78d8ec05a ("mtd: nand: Qualcomm NAND controller driver")
Cc: stable@vger.kernel.org
Signed-off-by: Abhishek Sahu <redacted>
---
drivers/mtd/nand/qcom_nandc.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
index 57d483a..bc0408c 100644
--- a/drivers/mtd/nand/qcom_nandc.c
+++ b/drivers/mtd/nand/qcom_nandc.c@@ -1,5 +1,5 @@ /* - * Copyright (c) 2016, The Linux Foundation. All rights reserved. + * Copyright (c) 2016-2017, The Linux Foundation. All rights reserved. * * This software is licensed under the terms of the GNU General Public * License version 2, as published by the Free Software Foundation, and
@@ -1893,7 +1893,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host *host) | wide_bus << WIDE_FLASH | 1 << DEV0_CFG1_ECC_DISABLE; - host->ecc_bch_cfg = host->bch_enabled << ECC_CFG_ECC_DISABLE + host->ecc_bch_cfg = !host->bch_enabled << ECC_CFG_ECC_DISABLE | 0 << ECC_SW_RESET | host->cw_data << ECC_NUM_DATA_BYTES | 1 << ECC_FORCE_CLK_OPEN
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation