Hi Nicola

On Tue, Dec 20, 2016 at 9:01 PM, Nicolas Saenz Julienne
[off-list ref] wrote:

This adds support for sbs-charger compilant chips as defined here:
http://sbs-forum.org/specs/sbc110.pdf

This was tested on a arm board connected to an LTC4100 battery charger
chip.

Signed-off-by: Nicolas Saenz Julienne <redacted>
---
 v3 -> v4
 - drop "lltc,ltc4100" compatible string for now

 v2 -> v3:
 - add readable_reg() function to regmap config
 - update compatible strings with part number

 v1 -> v2:
 - add spec link in header
 - use proper gpio/interrupt interface
 - update regmap configuration (max register & endianness)
 - dropped oldschool .supplied_to assignments
 - use devm_* APIs
 drivers/power/supply/Kconfig       |   6 +
 drivers/power/supply/Makefile      |   1 +
 drivers/power/supply/sbs-charger.c | 274 +++++++++++++++++++++++++++++++++++++
 3 files changed, 281 insertions(+)
 create mode 100644 drivers/power/supply/sbs-charger.c

Just some general comment, Can you add some more properties here to
know voltage and current?
Also, can you add other properties present in charging status register
like POWER_FAIL, VOLTAGE_OR,
CURRENT_OR etc.

Don't know weather it is feasible to add or not and Also, let me know,
if it is already been covered in
some part of the code.

Thanks
Manish Badarkhe
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html