On Thu, May 05, 2016 at 02:34:13PM +0200, Krzysztof Kozlowski wrote:

Hi,

This is a different, second try to fix usb3503+lan on Odroid U3 board
if it was initialized by bootloader (e.g. for TFTP boot).

First version:
http://www.spinics.net/lists/linux-usb/msg140042.html


Problem
=======
When Odroid U3 (usb3503 + smsc95xx + max77686) boots from network (TFTP),
the usb3503 and LAN smsc95xx do not show up in "lsusb". Hard-reset
is required, e.g. by suspend to RAM. The actual TFTP boot does
not have to happen. Just "usb start" from U-Boot is sufficient.

From the schematics, the regulator is a supply only to LAN, however
without toggling it off/on, the usb3503 hub won appear neither.


Solution
========
This is very similar to the MMC pwrseq behavior so the idea is to:
1. Move MMC pwrseq drivers to generic place,

You can do that, but I'm going to NAK any use of pwrseq bindings outside 
of MMC. I think it is the wrong way to do things. The DT should describe 
the devices. If they happen to be "simple" then the core can walk the 
tree and do any setup. For example, look for "reset-gpios" and toggle 
that GPIO. There is no need for a special node.

2. Extend the pwrseq-simple with regulator toggling,
3. Add support to USB hub and port core for pwrseq,

We discussed this for USB already[1] and is why we defined how to add 
USB child devices. The idea is not to add pwrseq to that.

Rob

[1] http://www.spinics.net/lists/linux-usb/msg134082.html
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html