Hello Krzysztof,

On 05/05/2016 08:34 AM, Krzysztof Kozlowski wrote:

On Odroid U3 (Exynos4412-based) board if USB was initialized by
bootloader (in U-Boot "usb start" before tftpboot), the HUB (usb3503)
and LAN (smsc95xx) after after successful probing were not visible in the
system ("lsusb").

In such case the devices had to be fully reset before configuring.
Reset by GPIO (called RESET_N pin) and by RESET field in STCD register
in usb3503 HUB are not sufficient. Instead full reset has to be done by
disabling and enabling regulator.

Signed-off-by: Krzysztof Kozlowski <redacted>
---

[snip]

 
+	lan_pwrseq: pwrseq2 {
+		compatible = "mmc-pwrseq-simple";

It feels strange to have a "mmc-pwrseq-simple" compatible for a USB power
sequence provider. As I mentioned in the other patch, I think there should
either be a DT binding for the USB pwrseq-simple with a "usb-pwrseq-simple"
compatible that binds to the same pwrseq-simple driver or maybe having a
generic DT binding for any device with a new "pwrseq-simple" compatible.

Patch looks good to me though, so after having a DT binding and changing
the compatible string:

Reviewed-by: Javier Martinez Canillas <redacted>

Best regards,
-- 
Javier Martinez Canillas
Open Source Group
Samsung Research America