Re: [Gta04-owner] [PATCH 0/3] tty slave device support - version 3.

Am 07.05.2015 um 16:56 schrieb Peter Hurley [off-list ref]:

On 05/07/2015 08:46 AM, Dr. H. Nikolaus Schaller wrote:

quoted

So I don’t think that being able to control the slave is a common property
of all UART-slave connections.

BTW: the GPS chip we use is doing something without any instructions. It starts
to send NMEA records right after power on. It would even be useful with a unidirectional
connection from GPS to UART. Hence there are no commands that need to be
sent through UART. Rather it just needs some GPIO to be activated or powered down
when /dev/tty is opened/closed.

In this example, the GPIO is a workaround for the lack of DTR.

Yes.

Our long ago proposal was to use DTR - but this did lead to make the GPS driver
present a “virtual gpio”, that could have been plumbed to a dtr-gpio phandle of the uart
driver. The only reason is that some piece of code must pulse-shape the DTR
to be fed into the real GPS control pin.0

But I agree that we should not have such “virtual gpios”, since they are not needed
(in either approach we discuss now).

quoted

So one could argue that in this real case (which we try to solve in an acceptable way
since 2 years) the fundamental/main interface (control command interface) of this chip
is the power on/off line. And UART isn’t involved at all. Or just as an “activity detector”.

The indirect nature of control in this case only reflects the workaround,
not the underlying concept. Control is still derived from the UART status.

Both devicetree and tty/serial can already represent independent control;
what is proposed is a way to express dependent control, and in all cases,
that control stems directly from either the UART state itself or via
commands sent over that interface.

Yes. This is why I propose that the tty/uart driver can send an internal notification
to the device driver. And the device driver can register to be notified by the UART
that is identified by the phandle of the slave DT entry.

Any target not requiring UART involvement doesn't (and probably, shouldn't)
be expressed as a slave device.

IMHO it is not obligatory to represent the direction of control by a parent>child
relation in DT. DT just needs to describe that there is a relation/connection.

The driver code already must “know” the direction of notifications.

BTW, there can even be control in reverse direction in some cases. E.g. the slave
driver wants to automatically set the baud rate of the uart, i.e. the slave controls
the uart on /dev/tty side.

If I have monitored some other discussion right, this is exactly done by a Codec
driver to tell its mcbsp counterpart about clock rates and data formats it should
expect. Maybe this is the reason why McBSP use (or are just happy with) the
phandle approach.

BR,
Nikolaus

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html