Re: [Gta04-owner] [PATCH 3/3] tty/slaves: add a driver to power on/off UART attached devices.

Hi!

quoted

In the case of our GPS, it receives control over the serial connection from
the UART,

Ahem - does it?

AFAIK the chip simply starts to emit NMEA records if powered on. There is no
command going over the serial interface to address it or control it.

Well _most_ GPSes enable you to control them over the serial
line. (Things like sampling rate, AGPS data upload, ...)

quoted

I think the GPS is “primarily" a uart-attached device.

But not in the same way as an I2C device.

Especially the serial interface is not a bus and not used for signalling and
power control. It is payload data (only).

Serial interface looks a lot like a (point-to-point) bus to
me. Similar to SATA, for example.
									Pavel
-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html