Re: [PATCH v2 1/3] Bluetooth: hci_h5: add WAKEUP_DISABLE flag

Hi Archie,

quoted

quoted

quoted

quoted

Some RTL chips resets the FW on suspend, so wakeup is disabled on
those chips. This patch introduces this WAKEUP_DISABLE flag so that
chips that doesn't reset FW on suspend can leave the flag unset and
is allowed to wake the host.

This patch also left RTL8822 WAKEUP_DISABLE flag unset, therefore
allowing it to wake the host, and preventing reprobing on resume.

Signed-off-by: Archie Pusaka <redacted>
Reviewed-by: Abhishek Pandit-Subedi <abhishekpandit@chromium.org>
Reviewed-by: Hilda Wu <redacted>

---

Changes in v2:
* Remove unnecessary variable

drivers/bluetooth/hci_h5.c | 83 +++++++++++++++++++++++++++-----------
1 file changed, 59 insertions(+), 24 deletions(-)

so the set does not apply cleanly to bluetooth-next

Applying: Bluetooth: hci_h5: Add runtime suspend
error: patch failed: drivers/bluetooth/hci_h5.c:11
error: drivers/bluetooth/hci_h5.c: patch does not apply

Hmm, it applies cleanly for me. Not sure what's going on.
Anyway I rebased and made a little change as v3, please take a look!

the v3 applied cleanly.

quoted

quoted

And I am really close to not accepting any patches for hci_h5.c anymore. This thing turns into crazy hacking and nobody is taking my hint to redo this as clean H:5 3-Wire serdev standalone driver.

Pardon my unfamiliarity, but could you share more about your vision of
a clean h5 driver? Should the RTL component be moved out to btrtl?
Do we have something as a reference?

so a while back I send a bt3wire.c sample driver around. That would be a good starting point.

Anyhow, the problem is that hci_uart.ko is inherent a line discipline driver from 2.4.x kernel days and it has been stacked and hacked on top of it. It has become a burden, especially in the light that you can have clean serdev based drivers now (like btmtkuart.c).

And yes, it would be following the 3-Wire H:5 spec and then deal with vendor specific details like btusb.c for example. And my hope would be that especially in the Realtek and Broadcom (RPi3 etc.) cases this can move into vendor specific blocks and shared between USB and UART transports.

I also send around a btuart.c sample driver that is solely serdev based and should replace all the cases where we have H:4 as transport.

Thanks for the pointers!

The files you mentioned are rather hard to find, so below I paste the
URL where I found them in case anyone else is also interested.

[RFC v2] Bluetooth: Add new serdev based driver for UART attached controllers
https://www.spinics.net/lists/linux-bluetooth/msg74918.html

[RFC] Bluetooth: Add new serdev based driver for 3-Wire attached controllers
https://www.spinics.net/lists/linux-bluetooth/msg74839.html

exactly these. I posted my initial work so that it can be continued by people with easier access to hardware.

Regards

Marcel