Hi Greg,

quoted

Currently, devices attached via a UART are not well supported in the
kernel. The problem is the device support is done in tty line disciplines,
various platform drivers to handle some sideband, and in userspace with
utilities such as hciattach.

There have been several attempts to improve support, but they suffer from
still being tied into the tty layer and/or abusing the platform bus. This
is a prototype to show creating a proper UART bus for UART devices. It is
tied into the serial core (really struct uart_port) below the tty layer
in order to use existing serial drivers.

This is functional with minimal testing using the loopback driver and
pl011 (w/o DMA) UART under QEMU (modified to add a DT node for the slave
device). It still needs lots of work and polish.

TODOs:
- Figure out the port locking. mutex plus spinlock plus refcounting? I'm
 hoping all that complexity is from the tty layer and not needed here.

It should be.

quoted

- Split out the controller for uart_ports into separate driver. Do we see
 a need for controller drivers that are not standard serial drivers?

What do you mean by "controller" drivers here?  I didn't understand them
in the code.

quoted

- Implement/test the removal paths
- Fix the receive callbacks for more than character at a time (i.e. DMA)
- Need better receive buffering than just a simple circular buffer or
 perhaps a different receive interface (e.g. direct to client buffer)?

Why?  Is the code as-is slow?

quoted

- Test with other UART drivers
- Convert a real driver/line discipline over to UART bus.

That's going to be the real test, I recommend trying that as soon as
possible as it will show where the real pain points are :)

maybe we can get the Intel LnP driver ported over and see how that one works out. It is one of the more complex ones when it comes to bootloader and firmware loading. Maybe Loic can take a stab at this. We would then also see how we can map the ACPI tables into a driver.

quoted

Before I spend more time on this, I'm looking mainly for feedback on the
general direction and structure (the interface with the existing serial
drivers in particular).

Yes, I like the idea (minor nit, you still have SPMI in a lot of places
instead of UART), so I recommend keeping going with it.

quoted

drivers/uart/Kconfig             |  17 ++
drivers/uart/Makefile            |   3 +
drivers/uart/core.c              | 458 +++++++++++++++++++++++++++++++++++++++
drivers/uart/loopback.c          |  72 ++++++

Why not just put this in drivers/tty/uart/ ?

Is it really then a TTY at all. Would be the UART become the basic core for a TTY? Having tty/uart/ seems a bit backward. Then again, it is just a directory name ;)

Regards

Marcel