On 16/06/2022 06:24, Tomer Maimon wrote:

Hi Krzysztof,

On Wed, 15 Jun 2022 at 20:03, Krzysztof Kozlowski
[off-list ref] wrote:

quoted

On 13/06/2022 02:25, Tomer Maimon wrote:

quoted

Hi Krzysztof,

Thanks for your clarification.

We can remove the dt-binding file and use numbers in the DTS,
appreciate if you can answer few additional questions:
1. Do you suggest adding all NPCM reset values to the NPCM reset
document or the reset values should describe in the module
documentation that uses it?

What is "NPCM reset document"? Are these reset values anyhow different
than interrupts or pins?

No, they represent the same values.

We do not document in the bindings actual pin or interrupt numbers...

quoted

quoted

2. Some of the NPCM7XX document modules describe the reset value they
use from the dt-binding for example:
https://github.com/torvalds/linux/blob/master/Documentation/devicetree/bindings/iio/adc/nuvoton%2Cnpcm750-adc.yaml#L61

This is NPCM750

quoted

If we remove the NPCM8XX dt-binding file should we describe the
NPCM8XX values in the NPCM-ADC document file?

What is NPCM-ADC document file? What do you want to describe there?
Again - how is it different than interrupts?

It is not different from the interrupts.
I will remove the dt-binding reset include file, the reset property
will use numbers and not macro's.

I have no clue what are you referring now... This is NPCM8xx and it has
no binding header with reset values. What to remove then?


Best regards,
Krzysztof

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel