Re: [PATCH v3 2/3] arm64: dts: imx8mq-evk: add one regulator used to power up pcie phy
From: Lucas Stach <l.stach@pengutronix.de>
Date: 2021-03-26 09:41:32
Also in:
linux-pci, lkml
Am Donnerstag, dem 25.03.2021 um 16:44 +0800 schrieb Richard Zhu:
Both 1.8v and 3.3v power supplies can be used by i.MX8MQ PCIe PHY. In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data sheet. When PCIE_VPH is supplied by 3.3v in the HW schematic design, the VREG_BYPASS bits of GPR registers should be cleared from default value 1b'1 to 1b'0. Thus, the internal 3v3 to 1v8 translator would be turned on. Signed-off-by: Richard Zhu <hongxing.zhu@nxp.com>
Reviewed-by: Lucas Stach <l.stach@pengutronix.de> I guess you need to split this patch out of the series and post it for Shawn to pick up into the imx DT tree, after the other two patches of the series have been accepted into the PCIe tree. Regards, Lucas
quoted hunk ↗ jump to hunk
--- arch/arm64/boot/dts/freescale/imx8mq-evk.dts | 1 + 1 file changed, 1 insertion(+)diff --git a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts index 85b045253a0e..4d2035e3dd7c 100644 --- a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts +++ b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts@@ -318,6 +318,7 @@<&clk IMX8MQ_CLK_PCIE1_PHY>, <&pcie0_refclk>; clock-names = "pcie", "pcie_aux", "pcie_phy", "pcie_bus"; + vph-supply = <&vgen5_reg>; status = "okay"; };
_______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel