[PATCH v3 1/3] dt-bindings: imx6q-pcie: add one regulator used to power up pcie phy
From: Richard Zhu <hongxing.zhu@nxp.com>
Date: 2021-03-25 08:59:32
Also in:
linux-pci, lkml
Subsystem:
open firmware and flattened device tree bindings, pci native host bridge and endpoint drivers, pci subsystem, the rest · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Lorenzo Pieralisi, Krzysztof Wilczyński, Manivannan Sadhasivam, Bjorn Helgaas, Linus Torvalds
Both 1.8v and 3.3v power supplies can be used by i.MX8MQ PCIe PHY. In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data sheet. When PCIE_VPH is supplied by 3.3v in the HW schematic design, the VREG_BYPASS bits of GPR registers should be cleared from default value 1b'1 to 1b'0. Thus, the internal 3v3 to 1v8 translator would be turned on. Signed-off-by: Richard Zhu <hongxing.zhu@nxp.com> --- Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt | 3 +++ 1 file changed, 3 insertions(+)
diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
index de4b2baf91e8..e6d1886144ce 100644
--- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt@@ -38,6 +38,9 @@ Optional properties: The regulator will be enabled when initializing the PCIe host and disabled either as part of the init process or when shutting down the host. +- vph-supply: Should specify the regulator in charge of VPH one of the three + PCIe PHY powers. This regulator can be supplied by both 1.8v and 3.3v voltage + supplies. Might be used to distinguish different HW board designs. Additional required properties for imx6sx-pcie: - clock names: Must include the following additional entries:
--
2.17.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel