Thread (67 messages) read the whole thread 67 messages, 5 authors, 2021-02-28

Re: [PATCH v8 03/22] counter: 104-quad-8: Return error when invalid mode during ceiling_write

From: William Breathitt Gray <hidden>
Date: 2021-02-22 02:07:57
Also in: linux-iio, lkml

On Sat, Feb 20, 2021 at 10:30:03AM -0600, David Lechner wrote:
On 2/12/21 6:13 AM, William Breathitt Gray wrote:
quoted
The 104-QUAD-8 only has two count modes where a ceiling value makes
sense: Range Limit and Modulo-N. Outside of these two modes, setting a
ceiling value is an invalid operation -- so let's report it as such by
returning -EINVAL.

Fixes: fc069262261c ("counter: 104-quad-8: Add lock guards - generic interface")
Cc: Syed Nayyar Waris <redacted>
Signed-off-by: William Breathitt Gray <redacted>
---
  drivers/counter/104-quad-8.c | 5 +++--
  1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/counter/104-quad-8.c b/drivers/counter/104-quad-8.c
index 9691f8612be8..f0608b21196a 100644
--- a/drivers/counter/104-quad-8.c
+++ b/drivers/counter/104-quad-8.c
@@ -714,13 +714,14 @@ static ssize_t quad8_count_ceiling_write(struct counter_device *counter,
  	switch (priv->count_mode[count->id]) {
  	case 1:
  	case 3:
+		mutex_unlock(&priv->lock);
  		quad8_preset_register_set(priv, count->id, ceiling);
-		break;
+		return len;
  	}
  
  	mutex_unlock(&priv->lock);
  
-	return len;
+	return -EINVAL;
  }
  
  static ssize_t quad8_count_preset_enable_read(struct counter_device *counter,
What happens if the register is written to when in the wrong mode?

If it doesn't hurt anything, I would suggest always writing the register
instead so that users don't have to know worry about the fact that the mode
has to be set first.
Unfortunately this register is used for two different functions: as a
ceiling limit and as a preset value. When we're in the preset mode, the
value of this register will be used to set the counter value when an
interrupt occurs; whereas in ceiling mode, this value is used as the
upper counting limit for the counter. We should only set this value when
in the correct mode, lest we end clobbering the value for the other mode
(e.g. user sets ceiling value, but driver unexpectantly changes the
preset value).

William Breathitt Gray
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help