From: Thierry Reding <redacted>

Simple panels can only have a single power supply. The second listed
supply is not needed because it is also the input supply of the first
supply and therefore will always be on at the same time.

In retrospect the panel probably doesn't qualify as simple since it
apparently does need both of these supplies, even if in the case of the
Medcom Wide it isn't necessary to explicitly hook them up.

Signed-off-by: Thierry Reding <redacted>
---
 arch/arm/boot/dts/tegra20-medcom-wide.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/tegra20-medcom-wide.dts b/arch/arm/boot/dts/tegra20-medcom-wide.dts
index 049181421a86..a348ca30e522 100644
--- a/arch/arm/boot/dts/tegra20-medcom-wide.dts
+++ b/arch/arm/boot/dts/tegra20-medcom-wide.dts

@@ -59,7 +59,7 @@ backlight: backlight {
 	panel: panel {
 		compatible = "innolux,n156bge-l21";
 
-		power-supply =  <&vdd_1v8_reg>, <&vdd_3v3_reg>;
+		power-supply =  <&vdd_1v8_reg>; // <&vdd_3v3_reg>;
 		enable-gpios = <&gpio TEGRA_GPIO(B, 2) GPIO_ACTIVE_HIGH>;
 
 		backlight = <&backlight>;

-- 
2.24.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel