On Thu, Feb 13, 2020 at 12:15 AM Jaedon Shin [off-list ref] wrote:

quoted

2020. 2. 13. 오후 12:54, Florian Fainelli [off-list ref] 작성:

+Jim,

On 2/12/2020 6:59 PM, Jaedon Shin wrote:

quoted

This series enables the ARM based Broadcom STB SoCs and supports GPIO
based regulators for its power supplies. and this has an improvement on
devm_ APIS.

Which ARM-based SoCs did you try this on? We still have an issue with
the multiple dma-ranges that must be handled to support 7445 with memory
in the extension regions as well as 7278 and 7216.

I'm using BCM72604 which has only one memc. and device is Qualcomm Atheros
QCA6174 Wi-Fi module.

You apparently have a simple enough memory configuration such that the
current upstream driver will work.  But this will not work for a
7445-based chip or other BCM7xxx chips that either have a memory
region extension or a non-zero system memory offset.

IIRC, similar regulator code was submitted before as part of the
complete driver that could handle our curious DMA situation, but was
rejected because someone objected to us using a  generic list of
regulators without specific explanation for each in the device tree
documentations.  I hope you have better luck :-)

Thanks,
Jim

quoted

See comments in specific patches.

quoted

Jaedon Shin (3):
 PCI: brcmstb: Enable ARCH_BRCMSTB
 PCI: brcmstb: Add regulator support
 PCI: brcmstb: Drop clk_put when probe fails and remove

.../bindings/pci/brcm,stb-pcie.yaml           |  8 +-
drivers/gpio/gpio-brcmstb.c                   | 13 +++-
drivers/pci/controller/Kconfig                |  2 +-
drivers/pci/controller/pcie-brcmstb.c         | 78 ++++++++++++++++++-
4 files changed, 97 insertions(+), 4 deletions(-)

--
Florian

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel