On Wed, 17 Oct 2018 09:10:45 +0200
Boris Brezillon [off-list ref] wrote:

On Wed, 17 Oct 2018 09:07:24 +0200
Boris Brezillon [off-list ref] wrote:

quoted

On Wed, 17 Oct 2018 02:07:43 +0000
Yogesh Narayan Gaur [off-list ref] wrote:
  

quoted

quoted

Actually there is no entry of s25fs512s in current spi-nor.c file.
For my connected flash part, jedec ID read points to s25fl512s. I
have asked my board team to confirm the name of exact connected flash
part. When I check the data sheet of s25fs512s, it also points to the
same Jedec ID information. { "s25fl512s",  INFO(0x010220, 0x4d00, 256
* 1024, 256, ....}

But as stated earlier, if I skip reading SFDP or read using 1-1-1
protocol then read are always correct. For 1-4-4 protocol read are
wrong and on further debugging found that Read code of 0x6C is being
send as opcode instead of 0xEC.

If I revert this patch, reads are working fine.    

Can you try with the following patch?
  

Hm, nevermind. The problem is actually not related to 4B vs non-4B mode
but 1-1-4 vs 1-4-4 modes.

Can you try with this patch applied?

--->8---

diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
index 9407ca5f9443..cf33d834698c 100644
--- a/drivers/mtd/spi-nor/spi-nor.c
+++ b/drivers/mtd/spi-nor/spi-nor.c

@@ -3132,6 +3132,17 @@ static int spi_nor_parse_sfdp(struct spi_nor *nor,
                switch (SFDP_PARAM_HEADER_ID(param_header)) {
                case SFDP_SECTOR_MAP_ID:
                        err = spi_nor_parse_smpt(nor, param_header);
+                       if (err) {
+                               dev_warn(dev,
+                                        "failed to parse SMPT (err = %d)\n",
+                                        err);
+                               /*
+                                * SMPT parsing is optional, let's not drop
+                                * all information we extracted so far just
+                                * because it failed.
+                                */
+                               err = 0;
+                       }
                        break;
 
                default: