Hello,

On 30.6.2016 13:13, Michal Suchanek wrote:

Hello,

On 25 June 2016 at 05:45,  [off-list ref] wrote:

quoted

From: Ondrej Jirman <redacted>

Use Xulong Orange Pi One GPIO based regulator for
passive cooling and thermal management.

Signed-off-by: Ondrej Jirman <redacted>
---
 arch/arm/boot/dts/sun8i-h3-orangepi-one.dts | 39 +++++++++++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
index b1bd6b0..a38d871 100644
--- a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
+++ b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts

@@ -109,6 +109,45 @@
        };
 };

+&cpu0 {
+       operating-points = <
+               /* kHz    uV */
+               1296000 1300000
+               1200000 1300000

First problem is that the board boots at 1008000 which is not listed
and the kernel complains.

Second problem is that the board locks up during boot with this enabled.

Do you have some suggestion for alternate configuration to test?

Just to verify, did you test with the entire series applied? (especially
the PLL1 clk application changes)

You may try dropping the highest operating point, it's probably overly
optimistic for Orange Pi One.

Is the power supply/cable you're using hard enough?

Where during the boot process does it lock up?

regards,
  Ondrej

Thanks

Michal

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 819 bytes
Desc: OpenPGP digital signature
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20160630/cf58b266/attachment-0001.sig>